Sun, 23 Jun 2019 00:50:22 +0300
added a test for BFC INVERTNEXT not followed by a type-1 line
24 | 1 | [scaling restrictions] |
2 | axle.dat = y-scaling only | |
3 | axleend.dat = y-scaling only | |
4 | axl?hol?.dat = y-scaling only | |
5 | axlesphe.dat = no scaling | |
6 | bushloc?.dat = no scaling | |
7 | steerend.dat = no scaling | |
8 | connect.dat = no scaling | |
9 | connect?.dat = no scaling | |
10 | confric?.dat = no scaling | |
11 | connhol?.dat = no scaling | |
12 | beamhole.dat = no scaling | |
13 | peghole.dat = y-scaling only | |
14 | peghole?.dat = y-scaling only | |
15 | npeghol?.dat = y-scaling only | |
16 | tooth*.dat = no scaling | |
17 | daxle.dat = y-scaling only | |
18 | daxlehole.dat = y-scaling only | |
19 | daxlehub.dat = y-scaling only | |
20 | dtoothc.dat = no scaling | |
21 | stug?*.dat = no scaling | |
22 | arm?.dat = no scaling | |
23 | clh?*.dat = no scaling | |
24 | 4-4crh?.dat = no scaling | |
25 | clip?.dat = no scaling | |
26 | clip??.dat = no scaling | |
27 | finger1.dat = no scaling | |
28 | h[12].dat = no scaling | |
29 | plug34.dat = no scaling | |
30 | wpin*.dat = no scaling | |
31 | bump5000.dat = no scaling | |
32 | slotm.dat = no scaling | |
33 | handle*.dat = no scaling | |
34 | rail12v.dat = no scaling | |
35 | primotop.dat = no scaling | |
36 | primobot.dat = no scaling | |
37 | zstud.dat = no scaling | |
38 | # no scaling on studs | |
39 | stud*.dat = no scaling | |
40 | # allow y-scaling only on stud4 for historical reasons | |
41 | stud4.dat = y-scaling only | |
42 | # allow -1 y-scaling only on some stud primitives for historical reasons | |
43 | stud3.dat = stud3-like scaling | |
44 | stud4s.dat = stud3-like scaling | |
45 | stud4s2.dat = stud3-like scaling | |
46 | stud16.dat = stud3-like scaling | |
47 | stud21a.dat = stud3-like scaling | |
48 | stud22a.dat = stud3-like scaling |